光耦继电器应用

1．Power storage system‍ 蓄电系统

2．Smart meters‍‍ 智能电表

3．Automatic meter reading‍ 自动抄表‍

4．Telecommunications‍ ‍ TELECOM电信设备

5．Instrumentation‍ 测量仪器

6．Medical equipment‍ 医疗设备

7．Communications equipment‍ 通信设备

8．Programmable controller‍ PC设备

9．Security Equipment‍ 防范・防灾机器

10．OA equipment‍ OA设备

11．If you are a user experiencing difficulty with solid-state relays and triacs:‍ 计时器

12．‍Microprocessor System I/O Board 在计算机系统I/O板中的应用

1.For Charge and Discharge 充放电用途

AP- Series SSR (APS Photo Relays) is used to switch charge and discharge. We recommend solid state relays for applications where there will be frequent ON/OFF switching.

AP-x Series SSD（APS Photo Relays）用于充电・放电时的切换。
对于ON/OFF切换次数较多的用途，建议使用光电耦合器。

2. For preventing an inrush current into capacitors when charging (pre-charge circuit)防止充电时发生的电容冲击（预充电电路）

APx Series SSR (APSPhotoRelays), 10A and 20A types of relays are used for preventing an inrush current into capacitors when charging. We recommend solid state relays for miniaturization and 10A and 20A types of relays for high voltages.

AP-x Series SSD（APS Photo Relays）、10A、20A型继电器用来防止充电时电容产生的冲击电流。
要求小型的情况下，建议使用光电耦合器、高电压时为10A、20A型继电器。

During device startup, the inrush current prevention relay turns ON and the main relay turns ON after the capacitor is charged.
Effective for protection against inrush currents that occur when charging the capacitor.

启动机器时，用来防止冲击的继电器将会置ON，电容充电后，主继电器将会置ON。
对于电容充电时产生的冲击电流，可有效地发挥保护作用。

3.For Insulation Detection绝缘检测用途

APS Photo Relays are used for monitoring storage battery units for insulation deterioration. If the insulation in a unit deteriorates, a ground-fault current passes when the relay is turned ON, and a sensor detects the current. High load voltage type APS Photo Relays are ideal for use with storage batteries, which carry high voltage.

使用APS Photo Relays对蓄电池单元的绝缘劣化进行监控。单元内部发生绝缘劣化的情况下，置ON时将会有接地电流流过，传感器将会进行检测。由于蓄电池属于高电压，因此适合使用高耐压型APS Photo Relays。

Inside of a storage battery unit

When insulation of high voltage area and chassis is deteriorated

高电压部与底盘的绝缘发生劣化时

1. APS Photo Relays is turned on.

APS Photo Relays为ON
2. The current sensor detects a ground-fault current.

电流传感器检测接地电流
3. An alarm signal is output.

警报信号的输出

4.For Battery Monitoring电池监控用途

APS Photo Relays are used in a circuit for monitoring charging voltages of a battery cell group. Compact APS Photo Relays capable of frequent switching are ideal for this type of use. Use of the relays allows for insulation from high voltage areas.

将APS Photo Relays用作电池组（群）充电电压的监控电路。适合使用小型尺寸、可高频度开闭的APS Photo Relays。通过使用继电器，从而可与高电压部分实施绝缘。

When charging the capacitor

电容充电时

1，APS Photo Relays on the battery cell side are turned ON.

电池组的APS Photo Relays为ON

2，The capacitor is charged.

电容开始充电

When measure

测量时

1.APS Photo Relays on the battery cell side are turned OFF.

电池组的APS Photo Relays为OFF‍

2. APS Photo Relays on the measurement side are turned ON.

测量的APS Photo Relays为ON‍

3. The voltage of capacitor‍ (= voltage of battery cell group) is measured.

测量电容电压
　（＝电池组(群)的电压）

PHOTORELAYS & CONTACTORS

AQ SERIES PHOTORELAYS

New AQ Series PhotoRelays provides a compact DIP SMD and SOP package along. features greatly improved specifications for use in place of mercury and Mechanical Relays. With 1 Form A Type contact arrangement and high capacity ratings, the NEW AQ Series Relays can be used in applications such as security equipment, fire-preventing systems, industrial machines and HVAC applications such as thermostats, etc. These new Relays available in both surface mount and through hole varieties and are available in both tube and tape and reel packaging styles.

Download Datasheet